START TIME(S) 1. Turn the dial to the START TIMES position. 2. The factory preset is set on program A. You can select program B or C by pressing the button. 3. Use the or button to change the start time. (The start times advance in 15-minute increments). 4. Press the button to add an additional start time, or button for the next program.
X-Core - Station RepeatsA common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is requ Field Knowledge. An irrigation system that is repeating the cycle and continuously watering most likely has too many start times programmed into the controller. This video will explain what a start time is and how you can cancel those extra start times that you may not need. Too many start times have been programmed. Solution. Only one start time is necessary to activate a program. The Start Time numbers do not represent station numbers. Problem. There is no display. Cause. Check AC power wiring. Solution. Correct any errors. Problem. The display reads "No AC" Cause. There is no AC power present (the controller is The first step to programming your Hunter X-Core Controller is to set the date and time by following these steps. Turn the dial to the CURRENT TIME/DAY position. The current year will be flashing. Use the (+) or minus (-) buttons to change the year. Once completed the right arrow (>) to procced to set the month and day. X-Core - Station Repeats A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time. NOTE: In the Start Times dial position, the numbers 1-4 do not represent stations. The numbers represent the program I have to check start times every year on my unit after it's been off (plugged in) over the Winter. It seems to have a mind of its own. But that's really the only likely culprit. If you check all start periods in every program and only have 1 start time programmed and this keeps happening then the controller is defective.

Field Knowledge. Download MOV. Download WMV. One of the most common reasons for a sprinkler system to water intermittently and show the word DELAY on the display is because a delay time was programmed into the controller. This video will show you how to get rid of this delay.

ACTIVATING THE BATTERY After installing your X-Core, make safety to remove the battery contact insulator to allow the X-Core in keep time in the event of a power outage. CAUTION: RISK OF EXPLOSION IF SINGLE IS REPLACED UNTIL AN UNGEEIGNET TYPE. DISPOSE OF USED BATTERIES AC- CORDING TO THE INSTRUCTIONS. Page 11: Connecting A Master Valve 0afA8p.
  • u4ykeow1xn.pages.dev/379
  • u4ykeow1xn.pages.dev/12
  • u4ykeow1xn.pages.dev/47
  • u4ykeow1xn.pages.dev/14
  • u4ykeow1xn.pages.dev/24
  • u4ykeow1xn.pages.dev/165
  • u4ykeow1xn.pages.dev/288
  • u4ykeow1xn.pages.dev/391

    • hunter x core start times